Anthem Statement D2v Operating Manual Download

Page: 60 / 102

4.4.1

FM • AM TUNER

The processor has an FM • AM tuner. The selected station is common to all paths.

Manual Tuning:

After selecting the desired band by pressing

FM • AM

, use the

buttons (remote

control) or press

TUNE

and rotate the Master Control Knob (front panel).

Automatic Tuning:

To find the next station, press

SEEK

. To scan and listen to all available

stations for a few seconds, press and hold

SEEK

for about a second.

The

indicator on the display will change to

Prv

Nxt

. To stop

scanning, press one of the

SEEK

buttons to return to Seek mode, or press

TUNE

to tune manually (front panel only). Press

TUNE

a second time to restore the

regular functions and display (the TUNE function does not time out).

Direct Tuning

(remote control only)

A station’s frequency can be entered as a four-digit number. For example, to tune into 98.3 FM, press and hold

SELECT

until the display shows “<blank>0.0” in the lower left corner, then press

Presets:

18 FM and 6 AM stations can be stored. The presets are divided into four banks of six. By repeatedly pressing

FM • AM

, the display will show that you are cycling through FM1, FM2, FM3, and AM. Once you have selected

the desired bank, you can store the currently tuned radio station by pressing and holding one of the six
preset keys (

through

) for about a second. You can even do this while scanning for stations. The lower line

of the display briefly flashes once the station is stored. To skip a preset, set it to 87.5 FM or 530 AM.

To recall a preset, select the bank that it is in, then press the respective preset key. From the remote control,
you can also use the

CH+

and

keys to run through all FM or AM presets.

ST / HiB / M

(front panel only)

If FM reception is weak, switching a station out of stereo can reduce or eliminate
unwanted noise. Press

ST / HiB / M

repeatedly to cycle through Stereo, Hi-Blend, or

Mono. Hi-Blend offers an alternative to Mono, offering decreased noise without the
complete loss of stereo – it decreases hiss and noise by reducing some stereo separation
only at higher frequencies. The setting is memorized for each preset.

4.4.2

SIMULCAST

Simulcast allows you to select one video source and a different audio source. For example, you could view
a sports event on TV while listening to your favorite FM • AM station. Simulcast is available for all paths.

Press and hold the desired video source button for 2 seconds. The display shows “Video Source” and the
video source in the top line, and “SELECT AUDIO SOURCE” in the bottom line – while this is on the display,
press another source button to select the audio source. When the regular display returns, the source LED
indicates the video source, and the display shows the audio source next to a “+”.

HDMI audio cannot be

used in Simulcast mode.

To exit from Simulcast mode, press any source button – both the audio and video will switch to this selection.

4. OPERATION

continued …