Anthony Lifgtates, Inc.
18
L-501 Models
www.anthonyliftgates.com
800-482-0003
Direct Battery Connection
This method is not recommended because it allows
the unauthorized use of the liftgate when the truck is
unattended. Refer to “6.5 Direct Battery Connection
Option” on page 25.
Cut-Off Solenoid Connection
To prevent unauthorized use, use “6.6 Cut-Off Solenoid
Connection Option” on page 26.
Cut-Off Switch Connection
To prevent unauthorized use, use “6.7 Cut-Off Switch
Connection Option” on page 26.
WARNING
Anthony Liftgates strongly recommends the
installation of a power cut-off solenoid (“6.6
Cut-Off Solenoid Connection Option” on page
26) or cab cut-off switch (“6.7 Cut-Off Switch
Connection Option” on page 26). Allowing power
to the liftgate when the truck is unattended can result
in serious injury or death.
24. Cut the power cable to length, strip the end, and
crimp on a connecting lug per “6.3 Cable Lug
Installation” on page 24. Connect the power cable
to the pump solenoid post marked “BAT”. Use the
remaining cable and supplied lugs to ground the
pump to the truck’s chassis.
25. Using the supplied ground cable, ground the truck
battery to the frame.
NOTICE
The liftgate must be properly grounded. A ground
wire, the same gauge or larger as the liftgate
power cable, must be connected from the negative
post of the battery or batteries to the truck’s frame. If the
truck is properly grounded, no further action is required. If
the truck is not properly grounded, add a ground wire.
If this recommendation is not followed, damage to the
truck may occur. Improper grounding can cause the
electrical current to travel through brake lines, steel
braided power steering hoses, or other chassis wiring
causing failure to these components! Failure of these
components could result in loss of vehicle control.
26. Install the provided license plate bracket on the
streetside H-frame using two 5/16-18 x 3/4” bolts.
Install the truck license plate on the bracket.
27. Replace the license plate lights with the provided
lights by splicing into the existing harness. Install the
license plate lights into the holes in the bottom of the
pump reservoir compartment. Be certain to get all
the prongs on the light socket through the hole.
NOTICE
To prevent a blown fuse, make sure the truck battery is
disconnected before cutting the wires to the license plate
lights.
Summary of Contents for ALB-1500
