L-501 Models
25
Anthony Lifgtates, Inc.
800-482-0003
www.anthonyliftgates.com
6.4.1
Clip or Tie Wrap Installation Method
Fasten the power cable to the truck body. Locate one
fastener (battery side) within three inches of the end of
the fuse assembly. Locate the other fastener (power unit
side) within eight inches of the fuse assembly.
A-1073
TO LIFTGATE
Approx. 8"
Approx.3"
6.4.2
Bolt-On Method
A-1074
Approx.6"
Approx.6"
1. Attach the fuse holder to the truck body using #10 or
#12 self-tapping screws or bolts, washers, and self-
locking nuts.
2. Fasten the power cable, as needed, to properly hold
it in place.
3. Using this method requires an extra length of cable on
one side of the fuse assembly to permit removal of the
fuse.
6.5
Direct Battery Connection Option
This method is not recommended because it allows
the unauthorized use of the liftgate when the truck is
unattended. To prevent unauthorized use, use either “6.6
Cut-Off Solenoid Connection Option” on page 26 or
“6.7 Cut-Off Switch Connection Option” on page 26.
CAUTION
Using the direct battery wiring connection is not
recommended because it does not remove power to the
liftgate when the truck is left unattended. A cut-off switch
or cut-off solenoid will prevent the unauthorized use of the
liftgate when the truck is not in use.
ALI-00116
+
–
LONG
POWER
CABLE
200 AMP
FUSE
GROUND
VEHICLE
BATTERY
LIFTGATE
SOLENOID
Power cable connected directly from power unit to battery.
1. Position the fuse assembly near the battery so the
short cable end will reach the positive (+) terminal.
2. Attach the fuse holder to the truck body using either
“6.4.1 Clip or Tie Wrap Installation Method” on page
25 or “6.4.2 Bolt-On Method” on page 25.
3. Route the long end of the power cable from the
fuse to the motor solenoid in the liftgate pump
compartment. If the power cable is longer than
required, cut it to the desired length and attach a
cable lug according to instructions in “6.3 Cable Lug
Installation” on page 24.
4. Connect the power cable to the motor solenoid.
Make sure the power cable is connected to the
correct motor solenoid post (the one not connected to
the motor housing with a metal strap or wire cable).
5. Connect the short end of the power cable to the
positive post of the battery.
6. The power unit should now be operational.
7. Coat all terminal ends, studs, and nuts with a Teflon
lubricant, grease, or other electrical connection
sealant to prevent corrosion.
Summary of Contents for ALB-1500
