Anthony Liftgates MTU-GLR Series, Maintenance Manual

Anthony Liftgates, Inc. 

12 

MTU-GLR Maintenance

www.anthonyliftgates.com  

800-482-0003

4.5  Replace the Power Cable Fuse

4.5.1  Replace the 200 AMP Fuse

WARNING

An electric arc can cause 

personal injury or property 

damage. To avoid personal 

injury, disconnect the power cable from the vehicle 

battery or batteries before replacing the fuse, or 

before disassembling the fuse holder. 

1.  Slide the rubber boots away from the fuse holder.

2.  Unscrew the fuse holder ends from the fuse holder 

body and pull it apart.

3.  Slide the fuse holder body one direction (left or right) 

to expose the damaged fuse.

4.  Loosen the screws from each end of the fuse, 

remove, and replace the fuse.  Retighten the screws.

5.  Re-assemble the fuse holder in reverse order.  Be 

sure the rubber boots are sealed around the fuse 

holder and power cable.

6.  Re-connect the power after you are certain the liftgate 

area is clear.

4.5.2  Replace the 175 AMP Fuse

CAUTION

To avoid injury or property damage, 

disconnect the liftgate’s power 

cable from the battery before 

starting to replace the fuse. An ”arc” can occur, resulting 

in personal injury or property damage if the power cable 

is connected to the battery.

1.  Cut the heat shrink tube to expose the fuse, mounting 

hardware, and lugs.

2.  Remove the bolt, washer, and lock washer from each 

end of the fuse.

3.  Use the A-133607, 175 Hi-Amp Fuse Replacement Kit 

for the replacement parts.

4.  Slide the new heat shrink tube over one side of the 

wiring.

5.  Bolt the new fuse to the cable lugs using the bolts, 

washers, and lock washer, as shown.

6.  Slide the heat shrink tube over the fuse, hardware, 

and lugs. Using a heat gun apply heat evenly to 

shrink the tubing.

7.  Reconnect the power cable to the battery after you 

are certain the platform area is clear.

Note:

  If the fuse continues to blow, contact your 

authorized dealer.

4.6  Checking Motor Start Solenoid and Power 

Cut-off Solenoid

2

1

ALI-00592

Motor start solenoid.

2

1

ALI-00695

Power cut-off solenoid.