Elevate
TM
Original Corner Assembly Instructions
3
STEP 1
Assemble the Worksurface
Place the three worksurface components
upside down on a non-marring surface. Align
each wing to the corner piece so the curved
outer edges line up and the channels at the
center of each piece meet. [A]
Align the two halves of each latch assembly so that
the threaded bolt hole on one half of the assembly
aligns with the unthreaded bolt hole. Loosely connect
the two halves of the assembly by driving one
3.5" Bolt through the unthreaded hole and into the
threaded hole. [B]
Place one latch assembly into the center slot of the
three slots where the corner worksurface component
meets one of the wings. Align the screw holes in the
latch assembly with the holes on the worksurface
components.
Attach the latch assembly to the tops with #6-9x1"
Flat-hd Screw using a Phillips screwdriver, then tighten
the 3.5" Bolt just as tight as it will go. Loosely install two
junction plates in the slots surrounding the latch
assembly with six more #6-9x1" Flat-hd Screws. [C]
Repeat for the second latch assembly and junction
plates on the other wing.
Tighten all Phillips screws.
Product
Quantity
Part Number
26
20mm Socket Head Cap Screw
16
325-5272-00
27
#6-9x1" Flat Hd Screw
44
325-5716-00
28
3/4" Phillips Head Screw
4
325-5370-00
29
Flat Washer
4
325-5379-00
30
Zip Tie Screw Mount
4
400-5152-00
31
Keypad Assembly
1
Keypad
400-5357-00
Keypad Slider
400-5358-00
32
2-meter Control Box Cable
1
400-5180-00
(not shown)
33
1-meter Control Box Cable
3
400-5182-00
(not shown)
34
Control Box
2
400-5215-00
35
Zip Tie Panel Mount
2
400-5239-00
36
10' Power Cord Y (not shown)
1
400-5240-00
37
Patch Cable (not shown)
1
400-5241-00
38
Basetube
2
500-1005-00
Product
Quantity
Part Number
39
Cross Tube (X)
1
500-5024-00
40
Cross Tube (Y)
1
500-5025-00
41
Leg
4
575-5018-00
42
Anthro Medallion
2
725-5014-00
43
Anthro 3 Way Wrench (not shown) 1
225-5196-00
44
Hex Driver (not shown)
1
375-5000-00
45
5/32" Hex Driver Bit (not shown)
1
375-5003-00
46
5mm Hex Key (not shown)
1
375-5014-00
47
Rubber Mallet (not shown)
1
375-5022-00
48
5mm Hex Key (not shown)
1
375-5014-00
49
1/4" Hex Key (not shown)
1
375-5024-00
50
#2 Phillips Bit (not shown)
1
375-5009-00
PARTS LIST
(CONTINUED)
3.5” Bolt
325-5194-00
#6-9x1” Flat-Hd Screw
325-5716-00
A
B
C
