XP-1
ANTIGRAVITY BATTERIES
//
310 527 2330
//
INFO@ANTIGRAVITYBATTERIES.COM
USER MANUAL
PERSONAL PRECAUTION
READ AND UNDERSTAND ALL SAFETY INFORMATION BEFORE USING THIS PRODUCT. FAILURE TO FOLLOW THESE
SAFETY INSTRUCTIONS MAY RESULT IN ELECTRICAL SHOCK, EXPLOSION, FIRE, WHICH MAY RESULT IN SERIOUS
INJURY, DEATH OR PROPERTY DAMAGE.
Do not leave the product in or expose product to extremely high temperatures such as direct hot sunlight, or on
dashboards or other extremely hot areas above 110°F (43°C). Swelling may occur. Stop use of product if this occurs
and contact manufacturer.
Do not use product for any use other than intended.
Do not use Jump-Start Port to power devices, it is ONLY for Jump-Starting.
Do not Jump-Start with less than 3 lights lit on Capacity Indicator.
Do not Jump-Start more than 5 seconds per attempt (overheating may occur).
Do not Jump-Start more than 3 attempts in a row without allowing to cool.
Do not allow the XP-1 to become wet; do not immerse in water.
Do not operate the XP-1 in explosive atmospheres, such as in the presence of flammable liquids, gases or dust.
Do not modify or disassemble; there are no serviceable parts inside.
Do not use as a replacement battery for vehicles.
Do not leave the XP-1 connected to vehicle. Remove within 40 seconds of starting vehicle.
Do not clamp the Red and Black Clamps together.
Do not allow Children to play with this product unsupervised. Not recommended for use by infirm persons.
Do not leave battery products unattended while charging.
Do not charge frozen batteries; charge only between 34°F and 104°F (1°C and 40°C).
Do not subject to heat higher than 120°F (50°C) or swelling of pack could result. Discontinue use if swelling occurs.
Do not store in locations where the temperature may exceed 110°F (43°C).
OPERATING PRECAUTIONS
Make sure the BLUE PLUG of the SMART CLAMPS is plugged and seated fully into the XP-1. This connection must
be good or it could overheat the unit.
Make sure to check all the battery connections are clean. Remove corrosion or dirt that prevents a solid connection
of clamps to vehicle battery terminals.
Make sure clamps have a good “bite” on Battery Terminals for the most power.
Make sure the XP-1 has a minimum 3 lights on the Capacity Indicator lit before Jump-Starting.
Make sure to remove the product from the vehicle battery within 40 seconds of Jump-Starting.
Remove Clamps from XP-1 when not in use.
Safety Precautions
2018
1)
2)
3)
4)
5)
6)
7)
8)
9)
10)
11)
12)
13)
14)
15)
16)
17)
1)
2)
3)
4)
5)
6)
