POWERSPORTS
ANTIGRAVITY BATTERIES
//
310 527 2330
//
INFO@ANTIGRAVITYBATTERIES.COM
Page 3 of 8
USER MANUAL
Installation
BATTERY INSTALLATION
Remove the Negative Cable, then Positive Cable from your old battery. Test fit your Antigravity Battery into place. Note:
Our batteries have a 4-Terminal design so you can turn the battery one-half turn to switch the Terminals location.
Check for proper fitment, and make sure wires are free from hazards. Please note that all models of Antigravity
Batteries are designed to replace a few different sizes of Lead/Acid Batteries, so there may be some minor variations
in height or fitment. Use the provided plastic blocks (slide into holes on the bottom of the battery’s case) to raise the
battery if necessary.
After verifying the fitment of the battery, secure the battery. Replace Positive and Negative cables and tighten the
nuts. A firm tightness is all that is needed (4.0 N-m or 3.5 lb-ft). Do not over-torque the battery terminals; damage
could result.
1)
2)
3)
PLEASE USE SAFETY! FOLLOW THESE PRECAUTIONS
Battery MUST be securely mounted into vehicle to prevent movement.
Be careful not to short-circuit the Battery connections on the frame, or other metal parts.
Battery and Cables should not be installed near hot pipes, in high heat areas, near sharp objects or metal parts.
Battery Cables should have some slack and not be tightly stretched.
Test for Parasitic Drains on your vehicle after battery installation (VERY IMPORTANT, see “Troubleshooting” section).
Older bikes (1990s and earlier) should update to a modern solid-state voltage regulator.
Test for properly operating charging system in your vehicle by a professional. Vehicles should never charge above
14.4v.
1)
2)
3)
4)
5)
6)
7)
