background image

Release Date

January 2014

1955 CHEVROLET WONDERBAR

AM/FM STEREO

Fits 150, 210, BEL AIR & NOMAD

RADIO INSTALLATION

and

OPERATING INSTRUCTIONS

AM/FM9.2

Model 283501B

Add   our  Bluetooth®   adapter  kit   option!

  Answer

incoming   calls   and   place   outgoing   calls   with   compatible
phones — all without having to fumble around for your cell

phone.   You   can   also   stream   music   from   any   compatible
phone or tablet — use the dedicated keys to skip or replay

tunes.   Built  in   USB  2.1   Amp   charger.  NFC   simple   pairing
function. 

ANTIQUE AUTOMOBILE RADIO, INC.

700 TAMPA RD. Palm Harbor, FL 34683 USA (727) 785-8733

For HELP, Questions or Comments 

email:

support@radiosforoldcars.com

Summary of Contents for 283501B

Page 1: ...ls and place outgoing calls with compatible phones all without having to fumble around for your cell phone You can also stream music from any compatible phone or tablet use the dedicated keys to skip or replay tunes Built in USB 2 1 Amp charger NFC simple pairing function ANTIQUE AUTOMOBILE RADIO INC 700 TAMPA RD Palm Harbor FL 34683 USA 727 785 8733 For HELP Questions or Comments email support ra...

Page 2: ...g Your radio has an AM dial made to look like the original In the background there is also an FM dial scale Both are illuminated at night There is a small LED in the background that will be red when the radio is set to the AM band green when the radio is set to the FM band and yellow when the receiver locks on to a stereo signal Turning the tuning knob will move the dial pointer up or down the dia...

Page 3: ...cas is 530 to 1710 kHz in 10 kHz steps and for all of Europe the UK and Japan it is 531 to 1629 kHz in 9 kHz steps The FM broadcast band in the Americas is 87 5 to 107 9 MHz in 200 kHz steps and for western Europe and the UK it is 87 5 to 108 0 MHz in 100 kHz steps Japan and eastern Europe FM frequencies are not compatible with this receiver Your radio is shipped with 4 speakers and North America ...

Page 4: ...y between the center pin of the antenna plug and the car body It should not read like an open circuit If you re in a metal building reception may be limited Try it outside Ignition Noise Usually caused by an ungrounded antenna shield The base of the antenna must make good contact with the car body This problem often shows up after a good paint job Make sure the engine grounding straps are in place...

Reviews: