Antunes, AJ HEBT-3V, Manual

HEBT-3V BUN TOASTER

10

P/N 1011314 Rev. D 05/16 

McDonald’s

Figure 8. Conveyor Locks

Figure 7. Conveyor Rollers

MAINTENANCE (continued)

Replacing Belts (Quarterly)

Over time, the Belts will begin to show signs of wear. 

This wear appears in the form of tears or discoloration 

of the belt, at which point the belts should be replaced.

NOTE: Belts should be removed ONLY during Belt 

Replacement or when required in a service situ-

ation. For proper operation, replace all belts on 

a quarterly basis, We recommend that Belts be 

replaced every quarter.

REMOVING BELTS

  1.  Turn the toaster’s power switch to the off position. 

The toaster enters a cool-down mode and will 

automatically shut down when complete.

  2.  Unplug the power cord once the cool-down period 

is complete.

  3.  Put on neoprene gloves. Remove the Bun Feeder.
  4.  Remove the Front and Rear Conveyor Covers by 

lifting up and away from the toaster.

  5.  Set the Compression Knob to 7.
  6.  Unlock the latch and open the left side panel.
  7.  To lock the front Conveyor Roller, face the front 

of the toaster. Use both hands and push down on 

the Front Conveyor Roller and pull towards you. 

This removes tension and locks the roller in place 

(Figure 7).

  8.  To lock the Rear Roller, face the rear of the 

toaster.  Use both hands and push down on the 

Rear Conveyor Roller and pull towards you.  This 

removes tension and locks the roller in place 

(Figure 7).

  9.  Lift the upper Belt Frame Lock. Then rotate down 

so it rests on the cam shaft of the rear conveyor 

roller. (Figure 8).

 10.  Pull down the lower Belt Frame Lock  

(Figure 8). 

  11.  Remove and discard the Front Belt (the recom-

mendation is to cut it in half so it cannot be used 

again). See Figure 9.

 12.  Remove and discard the Rear Belts (the recom-

mendation is to cut them in half so they cannot be 

used again). See Figure 9.

13.   Wipe all four rollers with a clean towel sprayed 

with sanitizer. Make sure to remove all debris from 

the rollers so they are as clean as possible.

Upper Belt 

Frame Lock

Lower Belt  

Frame Lock

Tense

Loose

Loose

Tense

Figure 9. Remove and Discard the Belts 

DO NOT REUSE THE BELTS! 

Crown 

Belt Wrap

Club/Heel 

Belt Wrap

Main Belt Wrap