DELUXE FOOD WARMER
10
P/N 1010678 Rev. F 09/04
DELUXE FOOD WARMER
11
P/N 1010678 Rev. F 09/04
OPERATION
General Information
ALL MODELS
When the operate button (Figure 5) is pressed and
released, power is supplied to the water pump (Water
Tank models) or solenoid valve (Direct Water Hookup
models). The pump/solenoid operates and water
sprays onto the heated steam generator (Figure 9).
The water flashes immediately into steam and steams
the product.
TIMER MODELS - DFW/DFWT/DFWF–150/250
EXCEPT DFWF-250 WITH MFG. NO 9100147
On Timer Models, one of two operational modes can
be used: Single Shot or Timed Cycle
Single Shot
The Operate Button (Figure 5) is pressed and released
to initiate a single steam shot. The Control Board
applies power to the Water Pump/Solenoid and a “shot”
of steam occurs.
Timed Cycle
The control is used to set the desired steamtime (up
to 99 minutes, 59 seconds). When the Start/Stop
Button (Figure 5) is pressed, the Control Board applies
power to the water pump/solenoid at regular intervals
for the duration of the displayed cycle time. The dis-
play counts down to zero when the cycle is complete,
sounds an audible signal, and then reverts back to the
original programmed cycle time. The unit is ready for
the next cycle when the green ready light is on.
IMPORTANT: Timer Models are factory programmed
for the following recommended settings:
• Total Cycle Time = [15.00] (15 minutes)
(Range: 3 sec. to 99 mins 59 secs)
• Shot Interval Time (SHO) = [00:20] (20 seconds)
(Range: 3 secs to 5 mins 59 secs). 20 seconds is
recommended.
• Water Volume (H
2
O) =
DFW/DFWT/DFWF-250 - [0_50]
DFW/DFWT-150 - [0_80]
(Range: 0.10 seconds to 2.50)
The above settings convert approximately 3/4 oz. (25
milliliters) of water into to steam every 20 seconds for
15 minutes. To change any of these settings see the
appropriate Operating Instructions for your specific unit.
Operating Instructions For (Non-Timer)
Models
1. Turn the Rocker Switch (power On/Off) to ON
(Figure 5).
2. Allow the unit to preheat for approximately 30
minutes.
NOTE: Do not push the operate button during
warm-up.
3. Open the Top Cover and place the product to be
steamed onto the Trivet, then close the Cover.
4. Press the operate button for 1 second then
release and wait 20 seconds for the steam to
penetrate the product. Repeat if product requires
more steam (see the Steaming Guide section of
this manual).
NOTE: Pressing and holding the operate button for
longer than 1 second at a time, and/or too often
(before 20 seconds), will flood out the generator
surface (Figure 9) and result in poor steaming.
5. Remove steamed product.
6. See the Steaming Guide section of this manual.
WARNING
To avoid injury, be careful when opening top
cover. Be sure to allow steam to escape before
putting hands or face over the steamer.
READY
UP
DOWN
PROGRAM
START/STOP
POWER
Figure 5. Operating Controls–Timer Models
Ready Light
Rocker Switch
(Power On/Off)
Operate
Button
Message
Display
Start/Stop
Button
