Antunes, AJ VCT-2000, Owner'S Manual

VERTICAL CONTACT TOASTER

11

P/N 1010838 Rev. P 10/16 

Burger King

Daily

CLEANING THE BLACK AND SILVER RELEASE SHEET, 

CONVEYOR BELT WRAPS, AND TOASTER

Tools Required:

 •  Heat-resistant gloves

•  Clean towels

  • Capital® Multipurpose Superconcentrate 
 

•  Sanitizer Solution

  1.  Turn the unit off, unplug the power cord, and 

allow the unit to cool for 30 minutes.

  2.  Use heat-resistant gloves to remove the Bun 

Feeder, Heat Shield, and Bun Chute (Figure 1). 

Wipe them with a damp sanitized towel and allow 

them to air dry.

  3.  Remove the Release Sheet and place it on a 

clean, flat dry surface.  Wipe the silver side 

with a clean towel (or approved no-scratch 

pad) dampened with 

Capital® Multipurpose 

Superconcentrate (HSC)

 (or other approved 

cleaner) immediately followed by a second clean 

towel dampened with sanitizer. Allow it to air dry 

before continuing.  

  4.  Clean the black side of the Release Sheet using 

the same process described in Step 3. 

  5.  Open the front Conveyor Cover. Inspect the 

Belt Wraps for tears or damage and replace if 

necessary following the instructions on page 

13 of this manual. If the belts are in good 

condition, firmly wipe the black cleated Belt 

Wrap from left to right and from top to bot-

tom with a clean towel (or approved no-scratch 

pad) dampened with 

Capital® Multipurpose 

Superconcentrate (HSC)

 (or other approved 

cleaner) immediately followed by a second clean 

towel dampened with sanitizer.

MAINTENANCE

WARNING

Turn the unit off, disconnect the power source, 

and allow the unit to cool down 30 minutes before 

performing any service or maintenance on the 

unit.

CAUTION

To prevent damage to the unit, do not use abra-

sive cleaners on the Release Sheet or belt wrap.

Failed Belt Wrap - Worn.

Failed Belt Wrap - Torn

  6.  Close the front Conveyor Cover, then open the 

rear Conveyor Cover, and clean the Belt Wrap as 

described in Step 5.

NOTE:  Belt Wraps should feel tacky after clean-

ing in order to grip the buns and pull them into the 

toaster. If the Belt Wraps are slick, repeat Steps 5 

and 6.

  7.  Close the rear Conveyor Cover, reinstall the Heat 

Shield, and plug in the power cord. Turn the unit 

on, count 10 seconds, then turn the unit off and 

unplug the unit.

  8.  Open the rear Conveyor Cover again, clean the 

newly exposed section of the Belt Wrap in the 

same manner as before.  Close the Conveyor 

Cover.

  9.  Open the front Conveyor Cover again and clean 

the newly exposed section of the Belt Wrap in the 

same manner as before.

 10.  Close the front Conveyor Cover and wipe the out-

side of the toaster with a clean, damp, sanitized 

towel.