VERTICAL CONTACT TOASTER
13
P/N 1010838 Rev. P 10/16
Burger King
Weld
Screws
Acorn Nuts
Spacers
Tensioner
Assy.
Tape
Figure 5. Replacing Roller Tensioner Assy.
2. Replace Tensioner Assembly and reassemble.
3. Make sure the spacers are placed inside the
Tensioner arm. The spacers are smaller than the
holes to allow the Tensioner to pivot freely.
MAINTENANCE (continued)
REPLACING CONVEYOR BELT CHAINS
1. Remove the old Conveyor Belt Chain.
2. Place the replacement Conveyor Belt Chain on
the top sprockets with hook ends down. Check
for correct positioning (Figure 4).
NOTE: The ends of the hooks must point down.
(Figure 4).
3. Wrap the Conveyor Belt Chain around lower
sprockets and hook both ends together.
NOTE: Make sure the Conveyor Belt Chain is
installed below the upper support rod and above
the lower support rod.
MEASURING ROLLER TENSIONERS
Measure the Roller Tensioner on both inner Conveyor
Covers (See below). The space between the inner
Conveyor Cover and bottom of the Tensioner wheel
should be 13/16” (2.1 cm) or the height of a U.S. Nickel.
Adjust or replace any damaged ones.
REPLACING ROLLER TENSIONERS
1. Remove the acorn nuts and old roller Tensioner
Assembly (Figure 5).
