Antunes, AJ VCT-2000, Owner'S Manual

VERTICAL CONTACT TOASTER

6

P/N 1010838 Rev. P 10/16 

Burger King

WARNING

ELECTRICAL SHOCK HAZARD.  FAILURE TO 

FOLLOW THE INSTRUCTIONS IN THIS MANUAL 

COULD RESULT IN SERIOUS INJURY OR DEATH.

•  Electrical ground is required on this appliance.

•  Do NOT modify the power supply cord plug.  If 

it does not fit the outlet, have a proper outlet 

installed by a qualified electrician.

•  Do NOT use an extension cord with this appli-

ance.

•  The toaster should be grounded according to 

local electrical codes to prevent the possibil-

ity of electrical shock.  It requires a grounded 

receptacle with separate electrical lines pro-

tected by fuses or a circuit breaker of the  

proper rating.

•  Check with a qualified electrician if you are in 

unsure if the appliance is properly grounded.

CAUTION

All electrical connections must be in accordance 

with local electrical codes and any other appli-

cable codes.

CAUTION

Bread may burn.  Therefore toasters must not be 

used near or below curtains or other combustible 

walls and materials.  Failure to maintain safe oper-

ating distances may cause discoloration or com-

bustion. 

Unpacking

  1.  Remove unit and all packing materials from   

shipping carton.

  2.  Open the included large box.  It should contain 

the following: 

•  Bun Chute (Figure 1)  

•  Bun Feeder (Figure 1) 

•  Two Release Sheets (Figure 1) 

•  Owner’s Manual 

•  Maintenance Card 

•  Authorized Service Agency Directory

  3.  Remove all shipping tape and protective cover-

ings from the unit and parts.

NOTE:  If any parts are missing or damaged, con-

tact Antunes Customer Service IMMEDIATELY at  

1-877-392-7856 (toll free in the U.S.) or 630-784-

1000.

Equipment Setup

Before placing the toaster into service, pay attention to 

the following guidelines:

  •  Make sure power to the unit is off and the toaster 

is at room temperature.

  •  Do NOT block or cover any openings on the unit.

  •  Do NOT immerse the cord or plug in water.

  •  Keep the cord away from heated surfaces.

  •  Do NOT allow the cord to hang over edge of table 

or counter.

  •  Connect the unit to the proper power supply. 

Refer to the specification plate for the proper  

voltage.

Assembling the Unit

NOTE: The factory has pre-installed a Release 

Sheet over the Platen (Figure 1).  Verify that it is 

properly in place before proceeding.

  1.  Remove the Bun Chute and Bun Feeder from the   

box and install (Figure 1).

IMPORTANT:  Make sure Heat Shield is activat-

ing the Conveyor Safety Interlock Switch (Figure 

1).  The conveyors will not rotate unless the Heat 

Shield is in place and switch is activated.

INSTALLATION

CAUTION

Failure to use Release Sheets may result in dam-

age to the unit and loss of warranty coverage.