Antunes, AJ VCT-2000, Owner'S Manual

VERTICAL CONTACT TOASTER

9

P/N 1010838 Rev. P 10/16 

Burger King

AUXILIARY AIR HEATER TEMPERATURE ADJUSTMENT

  1.  Turn the unit on and allow the toaster to warm-up 

until the display reads “USE”.

  2.  Press and hold both TEMP UP and TEMP SCALE 

buttons until the display flashes the set point tem-

perature, then release (Figure 6).

  3.  Press the TEMP UP button to raise the set point 

temperature or press the TEMP DOWN button to 

lower the set point temperature.   

NOTE:  The maximum Auxiliary Air Heater set point 

temperature is 400

°

F.

  4.  Release the button when the desired set point is 

displayed.

NOTE:  If no change in temperature is made within 

5 seconds, the display reverts back to the previous 

set point.

Hi-Limit Reset Button

A Hi-Limit Control turns off electrical power to the heat-

er and control circuits if the Platen Heater overheats.  

To reset the control, allow 10-15 minutes for the Platen 

Heater to cool, then locate the Reset Button at the rear 

of the unit (Figure 3).  Remove the black protective 

cap, press the Reset Button, and reinstall the protec-

tive cap.

NOTE: If the Hi-Limit requires continuous resetting, 

contact your Authorized Service Agency.

OPERATION (continued)

TEMPERATURE CONTROL PANEL

NOTE:  The term “set point temperature” refers to 

the desired temperature setting.

To display the actual Platen Heater temperature, pro-

viding it is over 440°F (227°C), press the TEMP UP 

button.

To display the actual Auxiliary Air Heater temperature, 

providing it is over 360°F (182°C), press the TEMP 

DOWN button.

To switch the temperature display between Fahrenheit 

(°F) and Celsius (°C), press and hold the TEMP 

SCALE button for 5 seconds.

PLATEN HEATER TEMPERATURE ADJUSTMENT

  1.  Turn the unit on and allow the toaster to warm-up 

until the display reads “USE”.

  2.  Press and hold both TEMP UP and TEMP DOWN 

buttons until the display flashes the Platen Heater 

set point temperature, then release (Figure 5).

  3.  Press the TEMP UP button to raise the set point 

temperature or press the TEMP DOWN button to 

lower the set point temperature.  

NOTE:  The maximum Platen set point temperature 

is 600

°

F (315°C).

  4.  Release the button when the desired set point is 

displayed.

NOTE:  If no change in temperature is made within 

5 seconds, the display reverts back to the previous 

set point.