Antunes DCH-1000, Owner'S Manual

P/N 1011306 Rev. D   12/17

3

IMPORTANT SAFETY 

INFORMATION

Use the following guidelines for safe opera-

tion of the unit.

y

Read all instructions before 

using equipment.

y

For your safety, the equipment is 

furnished with a properly grounded 

cord connector. Do not attempt to 

defeat the grounded connector.

y

Install or locate the equipment only 

for its intended use as described in 

this manual. Do not use corrosive 

chemicals in this equipment.

y

Do not operate this equipment if 

it has a damaged cord or plug, if 

it is not working properly, or if it 

has been damaged or dropped.

y

This equipment should be serviced 

by qualified personnel only. Contact 

your nearest Authorized Service 

Agency for adjustment or repair.

y

Do not block or cover any 

openings on the unit.

y

Do not immerse cord or plug in water.

y

Keep cord away from heated surfaces.

y

Do not allow cord to hang over 

edge of table or counter.

y

Turn the power off, unplug the 

power cord, and allow unit to cool 

down before performing any service 

or maintenance on the unit.

y

The equipment should be grounded 

according to local electrical codes to 

prevent the possibility of electrical 

shock. It requires a grounded 

receptacle with separate electrical 

lines, protected by fuses or circuit 

breaker of the proper rating.

y

All electrical connections must be in 

accordance with local electrical codes 

and any other applicable codes.

y

Do not clean this appliance 

with a water jet.

WARNINGS

Be advised of the following warnings when 

operating and performing maintenance on 

this unit.

y

If the supply cord is damaged, 

it must be replaced by the 

manufacturer or its service agent 

or a similarly qualified person 

in order to avoid a hazard.

y

Do not modify the power supply 

cord plug. If it does not fit the 

outlet, have a proper outlet 

installed by a qualified electrician.

y

Do not use an extension 

cord with this appliance.

y

Electrical ground is required 

on this appliance.

y

Check with a qualified electrician 

if you are unsure if the appliance 

is properly grounded.

y

If a chemical cleaner is used, 

be sure it is safe to use on cast 

aluminum. Observe all precautions 

and warnings on product label.

y

Inspection, testing, and 

repair of electrical equipment 

should only be performed by 

qualified service personnel.

y

Do not use abrasive materials. The 

use of these may cause damage 

to the stainless steel finish.

y

Chlorides or phosphates in cleaning 

agents (e.g. bleach, sanitizers, 

degreasers or detergents) could cause 

permanent damage to stainless steel 

equipment. The damage is usually in 

the form of discoloration, dulling of 

metal surface finish, pits, voids, holes, 

or cracks. This damage is permanent 

and not covered by warranty. 

The following tips are recommended 

for maintenance of your stainless steel 

equipment:

y

Always use soft, damp cloth for 

cleaning, rinse with clear water and 

wipe dry. When required, always rub 

in direction of metal polish lines.

y

Routine cleaning should be 

done daily with soap, ammonia 

detergent, and water.

y

Stains and spots should be sponged 

using a vinegar solution.

y

Finger marks and smears should be 

rubbed off using soap and water.

y

Hard water spots should be 

removed using a vinegar solution.