3
P/N 1012011 Rev. C 06/18
Safety Information
Installation
y
Read and understand all
instructions before installing or
using the eated display cabinetr
y
Install and locate the equipment
only for its intended use as
described in this manual.
y
All electrical connections
must be in accordance with
local electrical codes and any
other applicable codes. The
equipment must be grounded
according to local electrical
codes to prevent electrical
shocks. It requires a grounded
receptacle with separate electrical
lines, protected by fuses or a
properly-rated circuit breaker.
y
Electrical ground is required
on this appliance. Consult a
qualified electrician if there is any
uncertainty about whether the
appliance is properly grounded.
y
Do not modify the power supply
cord plug. If it does not fit the
outlet, have a proper outlet
installed by a qualified electrician.
y
Do not use an extension
cord with this appliance.
Operation
y
The toaster is furnished with
a properly grounded cord
connector. Do not attempt to
defeat the grounded connector.
y
Do not operate the toaster if it
has been damaged or dropped,
if it has a damaged cord or plug,
or if it is not working properly.
y
Do not block or cover any
openings on the equipment.
y
Do not immerse the cord
or plug in water.
y
Keep the cord away from
heated surfaces.
y
Do not allow the cord to
hang over the edge of
a table or counter.
Maintenance
y
Do not use abrasive materials;
they can damage the toaster’s
stainless steel finish.
y
Do not use corrosive
chemicals in this equipment.
y
Chlorides or phosphates in
cleaning agents (e.g., bleach,
sanitizers, degreasers, and
detergents) can permanently
damage stainless steel
equipment. The damage
is usually in the form of
discoloration, dulling of the
metal surface finish, pits,
voids, holes, or cracks. This
damage is permanent and is
not covered by warranty.
y
Use only chemical cleaners
that are safe for cast aluminum.
Observe all precautions and
warnings on product labels.
y
Always use a soft, damp cloth
for cleaning. Rinse with clear
water and wipe dry. When
required, always rub in the
direction of metal polish lines.
y
Routine cleaning should be
performed daily with soap,
ammonia detergent, and water.
y
Sponge stains and hard
water spots with a 50%
vinegar solution.
y
Rub off finger marks and
smears using soap and water.
y
Do not clean the toaster
with a water jet.
Service
y
Inspection, testing, and
repair of electrical equipment
must be performed only by
qualified service personnel.
y
Have the toaster serviced only
by qualified personnel. Contact
Antunes Technical Service
for adjustment or repair.
y
Turn the power off, unplug the
power cord, and allow unit
to cool to room temperature
before performing any
service or maintenance.
y
If the supply cord is damaged,
it must be replaced by the
manufacturer, its service agent,
or a similarly qualified person in
order to avoid an electrical hazard.
