5
P/N 1012011 Rev. C 06/18
Installation
1. Remove unit and all packing
materials from shipping carton.
2.
Open the Accessories Box. It
should contain the following:
y
Bun Chute
y
Bun Feeder
y
1 Belt Set
y
Owner’s Manual
NOTICE:
If any parts are missing or
damaged, contact Antunes
Customer Service IMMEDI-
ATELY at +1-877-392-7856
(toll free).
3.
Open the side door (Figure 1)
and remove all of the plastic ties
securing the toaster mechanism.
4. Remove all packing materials and
protective coverings from the unit.
5.
Wipe the entire exterior of the
toaster and the accessories
mentioned above with a hot damp
cloth. Allow to air dry
NOTICE:
Do NOT use a dripping
wet cloth. Wring out before
use.
6.
Attach the Bun Chute, Bun Feed
-
er, and Butter Wheel assembly.
7. Make sure the Compression Knob
is set to 3, the default setting.
When placing the toaster into service, pay
attention to the following guidelines.
y
The power cord is located
at the bottom of the unit.
The unit is designed to be
placed on a table that will
NOT pinch the power cord.
y
Make sure the power switch is off
and the unit is at room temperature
before plugging in the power cord.
y
Do not block or cover any
openings on the unit.
y
Do not immerse the power
cord or plug in water.
y
Keep the power cord away
from heated surfaces.
y
Do not allow the power cord to hang
over edge of table or counter.
y
Place the unit on a sturdy, level
table or other work surface.
y
Turn the power switch to
off (if it is set to on).
y
Ensure the line voltage
corresponds to the stated voltage
on the specification label and
power cord warning t
ag.
8. Plug the power cord into the ap-
propriate power outlet. Refer to the
specification plate for the proper
voltage.
Figure 1.
Gold Standard Toaster - 2H
Operation
1. Press and release the Power
button to turn the toaster on. Al-
low the toaster to warm up until
USE
appears in the display
2. Set the Compression Knobs to
the desired setting. The recom-
mended Compression Settings
are:
CROWN - #4 HEEL - #3
3. Insert product into the appro-
priate lane on the Bun Feeder
according to Bun Feeder labels.
Insert buns with the cut side fac-
ing down.
4.
Finished product drops into the
bun landing zone.
Light/Dark Adjustments
The light/dark value can be adjusted
when the unit is displaying “USE”.
1. To adjust the light/dark value,
press the
LIGHTER
or
DARK-
ER
button. The display will
change to show the current
light/dark value.
NOTICE:
The default light/dark
value is d0.
2. Press the
LIGHTER
or
DARK-
ER
buttons to change the light/
dark value. The adjustment
range is L1-L9 and d0-d9. L9
is the lightest, d0 is the middle,
and d9 is the darkest setting.
3. To save the light/dark value,
press the
PROGRAM
button or
wait 5 seconds until the screen
displays “USE”.
NOTICE:
Adjusting the light/dark
value does NOT change the
temperature. It changes the
speed of the conveyors. The
light/dark value will reset to
the default value of d0 when
the unit is turned off.
