7
P/N 1012011 Rev. C 06/18
Daily Cleaning
Clean Toaster and Belt Wraps
1. Press and release the Power
button to turn the unit off. The unit
enters a 45 minutes cool-down
mode and automatically shuts
down when complete.
NOTICE:
The belt rollers will continue
turning while in cool-down
mode. This allows the entire
belt to be cleaned.
2. Put on heat resistant gloves. Re-
move the Top Cover, Feeder, and
Chute (Figure 1).
3. Wash, rinse and sanitize the Top
Cover, Feeder, and Chute at the
3-compartment sink.
Inspect the belts
NOTICE:
Replace any belts that are
torn, folded, missing snaps,
or damaged. Belts should be
removed ONLY during belt re-
placement or when required in
a service situation (see images
on page 9 for examples). Refer
to the section titled Replacing
Belts for instructions on remov-
ing and installing belts.
1. Apply a small amount of KAY®
QSR Heat-Activated Grill & Toaster
Cleaner on a non-abrasive pad.
2.
Wash step
– Wipe with the non-
abrasive pad damped with the Grill
& Toaster Cleaner.
3.
Rinse step
– Wipe with a clean
towel dampened with water.
4.
Sanitize step
– Wipe with a clean
towel soaked in KAYQUAT® II
Sanitizer solution and allow to air
dry.
5. Clean the top and bottom belts
(each belt should follow the
Wash-Rinse-Sanitize step):
NOTICE:
Repeat Steps 3 and 4
as
needed to remove heavy
carbon buildup. Be sure to
wash-rinse-sanitize the belts
completely. Failure to properly
clean the belts will shorten the
life of the belts and result in
poor performance.
6.
Wipe the exterior surfaces of the
unit with a clean, sanitizer-soaked
towel and allow to air dry.
7.
Reinstall all accessories (Figure 1).
8. Turn n the unit on and test the unit
before returning it to operation.
Examples of damaged belts
Replace torn or folded belts
Replace the belt if snaps are missing or
damaged.
Replace belts that are wrinkled or distressed
around snaps or with snaps that are loose,
damaged, or missing.
