02
1.3 Technical Characteristics
Table - 01
07
(*) Frequency and voltage will be only the ones indicated on motor characteristics label.
2. Installation and Pre Operation
2.1 Installation
The Blender is to be installed onto a leveled surface approximately 850mm
high.
The High Performance Industrial Blenders were developed to be used in both
voltages: 110 or 220V . Upon receiving the Blender adjust its voltage according to the
power supply source using the voltage selector switch N° 07(pic.01) located at the
bottom of the machine. Adjust it if necessary.
The cord has a plug with two pins and a grounding wire . It is mandatory the
three of them to be connected before to start to use the blender
.
2.2 Pre Operation
IMPORTANT
When installing the Cup Nº02 (Pic.01) on the machine be sure it is perfectly fitted.
The Cup can be fitted on the machine in any position; which guarantees a perfect
operation.
First of all check if the Blender is firm in its position. It is recommended to work
with the machine on a flat surface with approximately 850 mm of height.
4.4 Operation
4.4.1 Advice
Be sure your hair is not loose in order to avoid getting caught by turning parts
which could lead to a serious accident. Tie your hair well up and/or cover your head with
a scarf.
The operation performed by not trained or skilled personnel shall be forbidden.
Never touch turning parts with your hands or in any other way.
NEVER operate machine without all original safety devices under perfect conditions.
4.5
After Finishing The Work
4.5.1
Precautions
Always TURN THE MACHINE OFF by removing the plug from the socket before
cleaning the machine.
Never clean the machine unless it has come to a COMPLETE STOP.
Put all components back to their functional positions before turning it ON again. DO
NOT place your fingers in between belts and pulleys nor chains and gears.
4.6
Maintenance
4.6.1
Danger
Any maintenance with the machine in working situation is dangerous. TURN IT
OFF BY PULLING THE PLUG OFF THE SOCKET DURING MAINTENANCE.
IMPORTANT
Always unplug the machine when emergency cases arise.
4.7
Advice
Electrical or mechanical maintenance must be done by qualified personal for
such operation.
Person in charge has to be sure that the machine is under TOTAL SAFETY
conditions when working.
5
Analysis and Problems Solving
5.1 Problem, causes and solutions
The High Performance Industrial Blenders were designed to operate with the
need of minimum maintenance but the natural wearing caused by longer use of the
equipment may occasionally cause some malfunctions.
If such problem occurs with your Blender refer to Table 02 in which the most
common situations are listed with recommended solutions.
Technical Data
Units
LAR-04
LAR-06
LAR-08
LAR-10
110/220(*)
110/220(*)
110/220(*)
110/220(*)
50 or 60(*)
50 or 60(*)
50 or 60(*)
50 or 60(*)
0,5
0,5
0,5
0,5
0,38
0,38
0,38
0,38
620
680
700
780
260
280
300
300
210
210
250
250
8,8
8,9
9,0
9,5
[V]
[Hz]
[CV]
[kW/h]
[mm]
[mm]
[mm]
[kg]
[kg]
[ rpm]
9,6
3500
9,9
3500
10,1
3500
10,5
3500
Voltage
Power Rating
Frequency
Consuption
Height
Width
Depth
Net Weigth
Shipping Weigth
Rotation
