Copyright Gianni Industries, Inc. All Rights Reserved.
P-MU-DG30 Published:2009.06.15 Page: 3/ 5
Followed By
「
03
」：
This will set the system to be used as : Slots 001~150 for PIN
codes only
Note:
When system format has the change, there’s a possibility the card stored would be
invalid. Please reset the system and input all cards /tokens.
Add card and deletion
Enter the Programming mode, Enter the slot position code
「
001~100
」
A.
Green
light comes on:
This slot position is ready to register the card
1.
Present card in front of the reader
Yellow LED blinks (beep)
enrolled
completed
（
repeat
）
2.
Present card in front of the reader
(3 audible beeps) another card has already
been input (duplicate card).
B.
Red
light comes on:
This slot already has a code registered
1.
Press
「＊＊」
(deletion)
Green light
Enter the slot position code again
Present the card in front of the reader
﹝
same as Step “A”
﹞
2.
Enter another slot card position
Add PIN codes and deletion
Enter the Programming mode, Enter the slot position code
「
101~150
」
A.
Green
light comes on:
This slot position code may register the PIN codes
Input 5 digit PIN codes
Yellow LED blinks (beep)
enrolled
（
repeat
）
B.
Red
light comes on:
This slot position code is registered
1. Press
「＊＊」
(deletion)
Green light
Press the slot position code again
Input 5 digit PIN codes
﹝
same as Step “A”
﹞
2. Enter another slot card position
Note 1:
The codes"12345" or master code are not be used for PIN code.
Note 2:
PIN codes operate open door
：「
???????????
＊＊＊＊＊＃」
「
???….
」
random codes,
「＊＊＊＊＊」
5 digit PIN codes,
「＃」
Enter
To Program Relocking Timer
Enter the Programming mode,
A.
Relay 1
：
Press
「＊
10
」
Followed by the number of seconds the relay should
open→
「
05
」
=5 seconds
（
01 ~99 = seconds
）
→
（
beep
）
→enrolled → Press
「
#
」
to exit from the programming mode, or program other operating.
B.
Enter
「
00
」
Sets the relay to latching mode.
(Correct code entered opens the relay,
and the relay stays open until the correct code is entered again).
C.
Relay 2
：
Press
「＊
20
」
Followed by the number of seconds the relay should
open
）
→
「
05 =5 seconds (01 ~99 = seconds). →
（
beep
）
→enrolled → Press
「
#
」
to exit from the programming mode, or program other operating.
D.
Enter
「
00
」
Sets the relay to latching mode.
(Correct code entered opens the relay,
and the relay stays open until the correct code is entered again).
Changing the Master codes:
Enter the Programming mode, Enter
「＊
00
」
Followed by the new 5 digit master
code→
（
beep
）
→enrolled
→
Enter
「
#
」
to exit from the programming mode, or
program other operating.
