If you use another platform holder, you just need to
fix it directly to the machine.
Tip: the washing liquid can be alcohol, detergent solution, etc.
3
.
There are two cases for washing:
Case 1: The printed objects are on the platform. Then
please use the platform holder to secure the platform
as shown below.
Case 2: The printed objects has been removed from the
platform
(suitable for small models)
. Then please use
the washing basket to hold the printed objects.
Tighten the platform securing knob
Choose the suitable platform holder:
①
Adjustable platform holder -
Suitable for model
with height
less than 115mm
.
②
Platform holder -
Suitable for models with height
greater than 115mm and less than 165mm
.
Note: The holes on the washing basket is 18mm. If the
objects are less than 18mm, please do not remove them
from the platform, and refer to the instructions on the left
to clean them with the platform.
The height of adjustable platform
holder can be adjusted after loosen
this black knob. Please tighten the
knob after adjustment
The washing liquid
shall not exceed the
maximum scale
