Cure mode
(After washing, post curing can increase the strength of the printed objects.)
It is suggested to air dry the model before proceeding to the post-cure process.
5
.
After the washing is completed, a beeping sound will indicate it’s finished. After the model is washed, it is
suggested to air dry the model before proceeding to the next post-cure process.
The side with "ANYCUBIC" must
to face forward
4
.
Touch the time icon to select the washing time, and then touch the start icon to start washing.
(If the lid has been removed during the operation, the program will be paused. And the program will
resume after cover back the lid.)
①
②
Tips: After washing, please remove and and seal the washing bucket to avoid spilling the washing liquid.
1
.
Switch the machine to cure mode by touching the Mode on the front panel.
2
.
Align the curing table with the hole of the platform and install (The washing bucket needs to be removed
first if it is on the platform). Place the objects on the curing table and cover the lid.
Align the holes
The side with "ANYCUBIC"
needs to face forward
Note: Tear off the protective film before use
