37
③ Check that the bed is leveled and set to a distance of approx. 0.1 mm.
④ Inspect if print mat needs replacement, or use masking tape instead.
⑤ add a brim or raft to the model in slicing software.
⑥ Check the bed temperature matches the filament.
6. Warping/curling of the printed object
① Check the bed temperature matches the filament
② Check the infill % of the Gcode. The higher the infill, the more likely to warp
③ add a brim or raft to the model in slicing software.
7. Layer shifting
① Print head moving too fast, slow down the print speed.
② Check X/Y belt and the driving wheel and ensure they are properly installed.
③ Lubricate the rods by grease and check all nuts and bolts remain tightened.
8. Freezing screen
① Inspect if the touch screen has been pressed by the metal frame at the edge.
② Check if there is any cracks, if so, please contact us at
support@anycubic3d.com
.
9. T0 sensor abnormal
① Check the wiring of the hotend and ensure a good connection
② Check if there is any bended pins inside the connector.
10. Print head move abnormal
① Check if choosing the right machine model in slicing software.
② Check if any plugins in the slicing software.
11. Print stopped halfway
① Check if the Gcode file is complete and not corrupted.
② Check no plugins in the Gcode file.
③ Use print offline instead of via USB.
