www.anycubic.com
14
Installation
1. Be cautious during assembly as some parts may have sharp edges.
2. It is suggested to use a flat desktop and place the parts in an orderly
manner for quick assembly.
3. The color of some parts may be different from what in the manual,
but the assembly is the same.
4. Firmware has been pre-uploaded to the motherboard. After
completing the assembly, please level the platform and load the
filament then you could start the first test print.
Note: Every unit of the printer has been inspected and tested for printing.
Therefore, in some cases, there might be very small marks left on the
print head or on the heated bed. Those will not affect the printing quality
and those mean the printer has been tested for the quality. The aluminum
beam has slight scratches or slight unevenness on the platform, which is
normal if it does not affect normal printing. Thank you very much for your
kind understanding.
Team
ANY
CUBIC
