www.anycubic.com
49
Troubleshooting
③
Nozzle clogged. Please try to briefly heat the print head to a
temperature higher than 230
°
C and manually push the filament into
the extruder. You can also clean it with 0.4mm nozzle cleaning
needle. If it doesn’t work, you may need to replace it.
④
Not enough cooling for the hotend.
⑤
The printer has been working above the maximum speed for a long
time, please reduce the speed.
⑥
Check whether the extruder is normal and whether the friction force
of the extruder to the filament is sufficient. Try to tighten or clean
the extruder wheel.
4. Filament leaking
①
Nozzle, heating block or throat tube is not tightened properly, try to
fix/replace it after cooling or contact customer service.
5. Layer shifting
①
Print head moves too fast, please slow down the print speed.
②
Check the belts and driving wheels and ensure they are properly
installed.
③
Drive current is too small.
6. No sticking to the bed
①
The nozzle is too far from the platform, please try to re-level; at the
same time set the "initial layer thickness" to 0.2 in Cura, and set the
"initial layer line width" (for example, set to 150) to improve the first
layer adhesion.
②
Print too fast at the bottom layer speed, reduce it to ~20mm/s
③
Ensure that the print platform is clean
④
Add a brim or raft to the model in slicing software
