Note: When calibrating with multiple test weights repeat the steps 4 to 5.
6) When the indicator shows , there are 2 options:
the start key to finish the calibration and return to weighing mode.
and finish the digit calibration and return to weighing mode.
Detailed diagram for digit calibration:
29 |
ANYLOAD 805HP Handheld Digital Weighing Indicator User’s Manual (V1710)
ANYLOAD 805HP Handheld Digital Weighing Indicator User’s Manual (V1710)
| 30
6.1) If no chains or hooks are used during the standard value calibration, press
6.2) If hooks or chains are used during the standard value calibration, press
, , , to input the re-zero A/D count. Press again to save
short pr ess
short pr ess
short pr ess
short pr ess
short pr ess
short pr ess
repea t cal ibr at e
ot her val ues
short pr ess
end cal ibr at e
short pr ess
input the
Ze ro A/D count
input the
st anda rd val ues
input the
cor respon di ng
A/D count
short pr ess
input the
cor respon di ng
A/D count
11. Troubleshooting Guides
12. Technical Specifications
PROBLEM
Defective battery
Defective button/s
Power button not
properly pressed
Digits flash (indicator)
Display does not respond
to load changes
Low battery
Faulty load cell
Display weight shows
large error
Scale is not Zeroed
before applying weight
Requires recalibration
Units (kg/lb) wrong
selection
See calibration
See operation
Wireless distance
shortened
Wireless indicator’s
battery is low
Adjust the RF Power
output in the indicator
See operation
Replace battery
Press ZERO before
applying weight
Out of calibration
Re-calibration
Replace battery
Requires authorized
service
No display in the indicator
POSSIBLE CAUSE
SOLUTION
Replace
Requires authorized
service
Press and hold ON/OFF
key for three seconds
Features & Specifications
Electrical Performance:
Link Connection/Interface
Non-linearity
Zero Temp. Drift
±
0.001%F.S. Max
±
10nV /
℃
Frequency-16 available
channels to avoid
interference (duplex)
Wired with RS-232
compatible interface
805HP-WL (Wireless
Indicator)
805HP (Wired Indicator)
®
®
