Manual Anytec 868 CAB
2017 (REV A)
Anytec Sweden AB
Magasinsgatan 7
903 27 UMEÅ
0770-220 210
- 8 -
1.9.2 Lifting with straps
Adjust the positions of the lifting straps so that the boat is suspended horizontally (in balance)
when it is lifted. Make sure that there is protection between the straps and the boat where
necessary, otherwise the the boat may be damaged (O). Use a lifting beam as in figure 1 in
order to avoid creating pressure on the rubber fender while lifting. The fenderlist can not take
the load if you don´t use a lifting beam. Do not stand beneath the boat while it is suspended.
(D)
Bild 1. Lifting beam of H-type
1.10 Warranty
Please see the instructions of the relevant subcontractor for any equipment supplied / fitted.
Anytec Sweden AB provides a 24-month warranty on its production. In the event of major
damage to the hull or metal parts, please contact your dealer for a consultation. If this is not
done within a reasonable time after discovering the damage / fault, the warranty will cease to
be valid. Warranty claims / complaints must be submitted in writing. Warranty work will be
carried out by the dealer or manufacturer unless agreed otherwise. In other respects we
operate in compliance with the applicable Consumer Sales Act.
https://www.boat-manuals.com/
