Note: For supply connections, confirm using correct breaker size and wire gauge.
Connected only to a circuit that is protected by recognized ground-fault circuit
interrupter (GFCI).
●
Make sure the appliance is intact, and the
fittings are complete.
●
Please make sure the main power supply,
water pressure, grounding condition,
ammeter and wire reach the standard of
installation requirement.
●
Clean all the impurities of the pipe by
allowing water to flow for a few minutes
before connecting the heater to the supply
line. Any residue or dirt in the pipes may
cause damage to the heater.
●
We strongly recommend installing a water
filter before the inlet of heater. Hard water or
water with high levels of minerals and alkali
can cause damage to this unit. Water
softening system is needed for this case.
Voltage 120V
240V
Wattage 3500W 6000W
Rated Current 29.5A
25A
Min. required circuit breaker 32A
32A
Min. wire size (L,N,L1,L2,E) 10 AWG 12 AWG
Max. water pressure 87 Psi (0.6 MPa)
Min. water flow to activate unit 0.4 GPM (1.5 L/min)
Weight 4.21 lbs
Product Dimensions (D×H×W)
3.86” x 6.3” x 7.8”
Water connections 1/2’’NPT
Model
WH-AZ035-M1
WH-AZ006-M1
●
It must be fitted with a pressure reducing
valve adjacent to the entrance when the inlet
pressure is higher than 150 Psi (1034kPa).
●
DO NOT install near tinder or a strong
magnetic field. The appliance can be installed
above or under the sink, and unit must only be
mounted with inlet & outlet pointing downward
or upward VERTICALLY near by the water
fittings.
●
It is recommended to install the appliance no
more than 4 ft from the point of use to save
power.
●
Avoid locations that are prone to dampness,
high humidity, moisture, or dust.
PG.4
PRODUCT SPECIFICATIONS
INSTALLATION GUIDELINE
