switch can't wash with water, do not put into the water or other liquid, you need to
clean with the soft wet cloth.
3.Disassembling the blade: Grasp the main blade holder with left finger ,and then
grasp the top part of the upper blade with right finger, lift the upper blade and
rotate it clockwise to unlock, lift the upper blade upwards to remove.
Note:The blade is very sharp and do not contact with the hand directly.
4.After clean, please wipe all the parts dry with soft cloth or air-dry, assemble
again and store in a cool and dry place.
NOTE:1).It is prohibited the components of this product for high temperature
disinfection.
2).Do not use chemical, steel, wooden or abrasive cleaners to clean the
unit to prevent the gloss loss.
Chapter
Ⅵ
Troubleshooting
Problem
Possible Reason
Solution
After connect power,the
product does not work
1. The cover lid is not
installed well.
Please install the cover lid properly.
The motor would have
a bad smell when using
it at the first few times.
For a new motor, it is
normal phenomenon.
After using several times, the product
still has a bad smell, please contact our
service department
Stop working during
operation
1. Low voltage
2. Overheating protection
for motor.
1 .Check whether the voltage is too low.
2.Let the chopper to cool for 20-30
minutes.
10
