5
NOTES
NOTES
Avoid dusty or humid rooms and rooms filled with soot or cigarette smoke.
The Plasma TV’s screen could get dirty, resulting in poor picture quality.
Avoid places where the screen is exposed to direct sunlight or strong artificial light.
If surrounding light should shine on the screen, the screen will appear white and be hard to see.
Do not install in places where the temperature is high or low.
Doing so could result in damage.
Additional fall prevention measures.
To protect the Plasma TV from tipping over due to earthquakes or shocks, fasten the two safety fittings to the screw
holes on the rear of the Plasma TV using the two safety fitting mount screws, then pass a commercially available rope
or chain through the fittings and secure the Plasma TV to a wall, pillar or other sturdy object using screws and hooks.
(Do not do this when using the separately sold ceiling mount unit or wall mount unit.) While moving the Plasma TV,
Pay attention to the rope or chain that tags along the back of the TV.
Image Sticking:
The plasma TV illuminates phosphor to display images. The phosphor has a finite illumination life. After extended
periods of illumination, the brightness of the phosphor will be degraded to such extend that stationary images would
burn-in that part of the screen as grayed-out images.
Tips to prevent such image sticking are:
* Do not display images having sharp brightness differences or hi-contrast images, such as monochrome characters
and graphic patterns for long.
* Do not leave stationary images appearing for long, but try to refresh them at appropriate intervals of time, or try to
move them using screen saver function.
* Turn down the contrast and brightness control.
Note:
Such “Image Sticking” constitute misuse are NOT COVERED by the manufacturer’s warranty.
Do not install the product close to smoke or moisture:
Fire or electric shock may be caused when the product is installed close to smoke or moisture.
Do not installed the product in an area with heavy dust or high humidity:
Fire or electric shock may be caused when the product is installed in a place with heavy dust or
high humidity.
Instructions for moving the product:
Ensure that the power connector and any other leads are unplugged before moving the product.
The power cable should be kept away from heat sources:
The heat produced by any heat source may melt the covering of the power cable.
Unplug the connector
Hold the power connector when removing the power cable:
Pulling the power cable itself may damage the wires inside the cable and cause fire or electric
shock.
Do not touch the connector with wet hands:
To avoid risk of electric shock.
Do not block or cover the vents:
Blocking the vents may cause overheating and fire.
Do not install the product in a place with little or no ventilation. Never cover the vents with
towels, blankets or dusters.
Summary of Contents for PD4264
Page 34: ...34...
