Part Number and Serial Number
If you encounter any trouble while booting your system, follow the
procedures accordingly to resolve the problem.
The Part Number and Serial number are printed on bar code label. You can find the bar
code label on the outside packing or on the component side of PCB. For example:
Make sure if the jumper settings for CPU and DRAMs are correct.
Clear CMOS, then plug the ATX power cord correctly.
(For P4 system, please also plug the 4pin(+12V) cord.
Install the VGA card. Then connect your monitor and keyboard.
The problem was probably caused
by power supply or motherboard
failure. Please contact your reseller
or local distributor for repairing.
Perhaps your VGA card or monitor
is defective.
No
Yes
No
Yes
It is very possible that your keyboard
is defective.
During system rebooting, press Del to enter BIOS Setup. Choose
“Load Setup Default".
The problem should be caused by the
IDE cables or HDD itself.
Re-install Windows 95, Windows 98 or Windows NT.
Yes
Yes
Turn off the power and unplug the AC power cable, then remove all
of the addon cards and cables, including VGA, IDE, FDD, COM1,
COM2 and Printer.
Turn on the power, and check if
the power supply and CPU fan
work properly.
Start
Check if there is display.
Press Ctrl, and Alt key at the
same time, hold them and then
press Del to see if the
system reboots.
Turn off the system and
re-connect the IDE cable.
Check if the system can
reboot successfully.
End
No
No
Serial No.
Part No.
Part No.
Serial No.
P/N: 91.88110.201
is part number,
S/N: 91949378KN73
is serial number.
Model name and BIOS version
Model name and BIOS version can be found on upper left corner of first boot screen
(POST screen). For example:
MX4LR-GN R1.00
Feb. 1. 2003 AOpen Inc.
Award Plug and Play BIOS Extension v1.0A
Copyright © 2003, Award Software, Inc.
MX4LR-GN
is model name of motherboard;
R1.00
is BIOS version
