64
To access the configuration menu, press the [
FUNC
] key, and then press the [
kHz
] key.
Press the [
DOWN
] key five times to select “UNIT” in reverse contrast.
Rotate the sub dial to select either dBm or dBu.
Press the [
MHz
] key to accept the entry and return to a standard display.
Alternatively, press the [
CLR
] key to abort entry.
Or, press the [
DOWN
] key to move to the next item on the configuration menu.
9-7 CONFIGURE ANT PROGRAM
The AR6000 has two antenna input ports and may be assigned according to the receive frequencies.
Note: 1. When the receiving frequency is below 25 MHz, antenna 2 must be used.
2. When the optional (external) antenna relay switch is connected,
up to 4 antennas may be used.
Configuring example: Antenna 1: 25 MHz ~ 100 MHz
Antenna 2: 200 MHz ~ 300 MHz
To configure the antenna program, perform the following steps:
1. Press the [
FUNC
] key, and then press the [
kHz
] key.
2. Press the [
DOWN
] key six times to go to “Configuration 2/3” and select “ANT PROGRAM” in
reverse contrast.
3. Press the [
MHz
] key.
4. Rotate the main dial to select Antenna 1.
5. Rotate the sub dial to select the desired program number 0.
If the programmed channel is empty, “----.------“ is displayed.
To delete the current channel, press the [
PASS
] key.
6. Press the [
1
], [
0
], [
0
], [
MHz
] key to enter the upper limit frequency.
Summary of Contents for AR6000
Page 1: ... AR6000 Super Wide band Multi mode Receiver Operating manual AOR LTD ...
Page 91: ...90 13 SPECIFICATIONS ...
Page 94: ...93 ...
