Aosom 370-109V80, Assembly Instruction Manual

8.

The connection of battery wires

A)

Remove the screws at the back of the saddle, take off the saddle.

B)Connect the wires to the battery, red side to red side, black side to
black side, otherwise, it may cause damage to the battery. (The black
side is already connected.)
C)Fix the saddle back and fasten by the screws.
D)Tight the battery with treadle bar before replace the battery and
connect the wires. Otherwise, it may cause accident.
E)Do not connect the positive and negative side of the battery by any
tools, otherwise, it may cause fire and explosion.
F)There may be harmful gas and pungent odor when charging. Keepfire
away from the battery in case cause any explosion.

1.

Before first use, please make sure the battery is charged not less than 16 hours. Otherwise, it may cause permanent and

unrepairable damage to the battery.
2. When charge, put the DC plug of the charger into the car socket first, then connect the charger with power.
3. When drive for 1-2 hours, please charge in time for 8-12 hours, but no longer than 16 hours.
4. The heat is normal when charging. But if the temperature is too high, please check in time if the electric current is too large
or there's any short circuit.
5. Do not charge if there's any water inside the socket, otherwise it may cause short circuit.
6. To avoid the damage to battery and charger or the electric lines, the vehicle should use the provided battery and charger only.
7. Do not charge the non-rechargeable battery. Remove the exhausted battery and handle it properly, keep it away from children.
8. Do not mix new and old batteries or different batteries.
9. Remove the treader bar to take out or put in the battery, ensure right polarity, avoid short circuit.
10.Charging should be done by an adult.
11.When the vehicle will be not used for long time, ensure it be charged once a month.
12.Do not put the conductor into the socket.
13.Charge in well ventilated, dry place. Do not open the battery or the charger.

9.

Function diagram

A)

When the battery wires connected with battery terminals, press the forward/

backward switch to "forward", press the food switch, the vehicle will move
forward; and stop when release;
B) Press the forward/backward switch to "backward", press the food switch,
the vehicle will move backward; and stop when release;
C) The front light will shine when moving.

10. Fuse

Charging

Figure 8

Forward and backward

Foot Switch

Figure 9

Forward and backward

Foot 
Switch

This product configure self-resetting fuse,when the driving car stopped,

mainly because of the c urrent exceeds the specified value,

at this time ,you should wait 8 seconds,then the fuse will  automatic reset.

To avoid the fuse trip cause cut the power ,please note the things as follows:

The max loading is 25kgs,do not over the loading. Do not drag everything.

Do not let the water or other liquid touched the circuit,battery and other parts.

Never modify the structure and the electric circuit systiem.