Specification
• World First ESVT Technology
• Energy Saving Vacuum Tank
• AOX Patent No: 10-0808904
• High Impact High Gloss ABS Resin
• Automatic Control for AOX Water Re ll
• Safety Faucet for Hot Water
• All Stainless Steel Tank
• Tank Capacity: 1L Hot Water / 3.2L Cold Water
• Chilling System: LG Compressor R-134a 40g Refrigeration Gas
• Water Temperature: Cold +/- 10 Degree Celsius, Hot +/- 80 degree Celsius
• Dimension (cm): W26 x D49 x H51 cm
• Net Weight: 17kg
• Gross Weight: 18kg
• Power Consumption: Compressor 80W (0.7A), Heater 350W
• Power: AC220V / 50Hz
How to Change Filters?
Notes:
It is normal to experience a “popping” sound or to have lots of air bubbles (that may cause the water to look cloudy) when the filters are
new. This is due to the air trapped in the new filters.
If you find some particles in the water, please do not be alarmed. The particles are tested by independent labs to be activated carbon or
alkaline minerals which is safe for consumption. The quality and taste of the water is dependent on the incoming water source and the
filter’s usage.
To ensure that you get optimal antioxidants and alkalinity, please follow the recommended filter change schedule. You may refer to the
date written on the sticker (pasted on the side of the dispenser) or when you hear the FCT (Filter Change Timer) beeping.
Photo E
Turn anti-clockwise
to remove the cover.
Tighten back the cover by
turning clockwise after
draining of water.
Photo F
Please lift up each lever
to dispense AOX water
1
2
Photo D
Use your finger to push
in the ring as shown in direction (1)
and hold it while you pull out the
tube as shown in direction (2)
Photo H
Insert the filters in the right
sequence by following the
colour code as shown above.
Photo I
Turn on the water valve
Troubleshooting Guide
• Please check the following before asking for support.
• The dispenser may not operate properly because the user is not familiar with the product use even if it is not
broken down.
• Please take the following measures. If there is still a problem, please contact Customer Service.
1. Close the water valve
(Photo A)
2. Turn off both switches
(Photo B)
3. Lift up both lever and drain off excess water
(Photo E)
4. Turn anti-clockwise to remove the cover and drain
off any excess water
(Photo F)
5. Pull up the tube
(Photo G)
and remove the whole
set of filters
(Photo H)
6. Insert the new filters in the same sequence
(Photo H)
7. Close the top cover and tighten the 2 nuts
(Photo C)
8. Turn on the water valve
(Photo I)
9. Wait for 15minutes for the water to flll up both
Hot/Cold tanks inside the dispenser, use a
container and lift up each lever to flush away
10 litres of water
(Photo E)
Turn on both switches
(Photo B)
and your AOX
dispenser is now ready to serve your family
10.
