6
MAIN STATION
Power Input
Available in 110V / 220V
Station Dimensions
204 (w) x 143 (h) x 212 (d) mm
Weight
2.5 Kgs.
HOT AIR GUN
Power Consumption
600W
Temperature Range
100°C 480°C
Heating Element Type
Metal Heating Core
Fan Type
Sirocco
Air Capacity
35 l/min (max)
SOLDERING IRON
Power Consumption
60W
Temperature Range
200°C 480°C
Heating Element Type
PTC Element
Output Voltage
24V
SPECIFICATIONS
27
CARE & MAINTENANCE
Replacing the heating element of the Hot Air Gun
1. Detach screws shown in the illustration, and slide off the nozzle.
2. Pop out the heating element, detach the heating element by pulling away
both side of the white plastic connector.
3. Unsolder the last two wires (Thermal sensor) connecting the hand piece
and heating element together.
4. Attach the new heating element’s sensor wires to the hand piece. this
can be done by soldering the wires together. Take note of the color code
of the wires. Use a heat shrinking tube or electrical tape to protect the
solder joints from shorts .
5. Reattach the white plastic connector.
6. Replace the nozzle and refasten screws in the hand piece.
screws
screws
Replacing the Fan
1. When the fan has been deemed inoperable or damaged it may be re
placed by the following steps.
2. Follow steps 1 and 2 of replacing the heating element.
3. Pull out the fan and unsolder the ends of its power wires. Take note of
the placement of the wires as the fan supply has a positive and negative
terminal.
4. Resolder the two wires to the new fan.
5. Replace the nozzle and refasten the screws in the hand piece.