26
Soldering Iron Tip
Always keep the solderplated section of the tip/nozzle coated with a small
amount of solder. Oxide coating on the tip of the nozzle reduces its heat
conductivity. Coating the tip with a small amount of fresh solder ensures
maximum heat conductivity is obtained.
Replacing the Soldering Iron Tip
1. Always unplug the device from the main power source when removing or
replacing the soldering tip.
2. If the tip is hot, use the heat resistant pad to pull it out.
3. Insert the new tip fully into the handle. If the tip is not fully inserted (or
if the tip is damaged), the device will show the following from the SOL
DERING IRON TEMPERATURE display panel (“8”).
Checking the soldering iron connection cord for damages
1. Remove the soldering iron tip and nipple.
2. Push the socket out from the handle assembly.
3. Measure the resistance values between the connector and the lead wires
at the socket are as follows:
CARE & MAINTENANCE
Pin 1 Red ( + )
Pin 3 Blue (ground)
Pin 5 Black ( )
If any value exceeds 0Ω (shorted)
or ∞ (infinitely large — open),
replace the handle assembly.
Soldering Iron Error Messages
1. Soldering Iron connection assembly is not
connected or not properly connected to the
receptacle on the control panel.
2. Soldering iron tip is damaged and needs to
be replaced.
3. Thermal sensor is either disconnected or
damaged and needs to be fixed or replaced.
7
●
Microprocessorcontrolled ESD safe equipment.
●
Leadfree compatible, 2in1 multifunctional repairing system. Combines
the functions of hot air gun and soldering iron in one package.
●
Uniquely designed, easygrip hand piece with integrated lownoise fan.
Provides snugfit clasp for easy control of hot air direction.
●
Digital offset for easy
digital temperature calibration from –70 to +70 degrees.
●
Siroccotype fan providing seamless airflow and circuit protection.
●
Equipped with hand piece holder for saving bench space and safety.
●
All digital display of hot air temperature, soldering iron temperature, and
air pressure with touch type panel controls for precision and ease of use.
●
Uniquely designed compound tip that integrates the ceramic heating ele
ment and sensor in just one component. Replacing tips is as easy as slip
ping it in/out of the compatible 24V soldering iron.
●
Userprogrammable 1 to 30minute idletoautosleep mode of hot air
gun (with 5 minutes as default) — switches OFF fan and heating element
when device is not in use for a long period.
●
Builtin autocooling process that protects the system and its components
from excessive heat, prolonging usage life.
●
Builtin, userprogrammable autosleep mode for soldering iron.
●
Hot air gun convectionstyle heating allows low hot air pressure to pass on target
device/s and concentrate on the solder joints. Usable as heat reflow device.
●
Compatibility with different kind of soldering tips. See page 22.
●
Compatibility with air nozzles of various types. See page 23.
●
Suitable for various SMD and BGA reworking tasks.
●
Excellent for reworking components made of plastic materials.
FUNCTIONS & FEATURES
