18
CARE and MAINTENANCE
Part No.
Description
10094
Hot air gun heating element
30106S
Plastic handle of hot air gun
S009
Hot air gun complete handle
20962
Hot air gun metal pipe
B012
Soldering Iron complete handle
C005
Desoldering gun heating element
3072D
Plastic handle of desoldering gun
B1003
Desoldering gun complete handle
Spare Parts Guide
Blower/Vacuum Air Terminal Filters
Filters should be cleaned and replaced regularly to avoid dirt which can clog the
air passage. More importantly, this will also effectively clean the toxic fumes
produced during soldering process.
Soldering Iron Tip
Always keep the solder-plated section of the tip/nozzle coated with a small
amount of solder. Oxide coating on the tip of the nozzle reduces its heat
conductivity. Coating the tip with a small amount of fresh solder ensures
maximum heat conductivity is obtained.
Replacing the Soldering Iron tip
1. Always turn OFF main power switch when removing or inserting a tip.
2. If the tip is hot, use the heat resistant pad to pull it out.
3. Insert the new tip fully into the handle. If the tip is not fully inserted (or if
the tip is damaged), the device will display “PLUG”. Indicating a problem
with the contacts of the soldering iron or the tip.
Replacing the heating element of the Hot Air Gun
The heating element is found in the middle part of the hot air gun. The
normal life of a heating element is 1 year under normal operating conditions.
Steps:
1. Loosen the 3 screws that secure the handle.
2. Slide off the plastic tube.
3. Disconnect the ground wire sleeve.
