6
SPECIFICATION
SPECIFICATION
MAIN STATION
Power Input :
available in 110V / 220V
Station Dimensions:
112(w) x 92(h) x 165(d) mm
Weight:
1.5Kg
HOT AIR GUN
Power Consumption:
600W
Temperature Range:
100°C 480°C
Heating Element
Metal Heating Core
Fan Type:
Sirocco
Air Capacity:
35 l /min (max)
19
SPECIFICATION
CARE AND MAINTENANCE
Heating element
The following steps would help prolong the life of the heating element.
◆
Always let the unit enter cool down and sleep mode first before
turning off the unit.
◆
Always turn the temperature knob fully counter clockwise and
airflow level at around mid point after each use.
Signs than overheat protection have been engaged :
●
Temperature does not rise even though heater LED is always ON.
●
Temperature is dropping even though heater LED is always ON.
Let the unit cool down first, if the overheat protection keeps on
engaging recalibrate the hot air gun.
Calibrating the hot air gun
In some cases, it may be necessary to synchronize the amount of
heat delivered by the Hot air gun with an external temperature sensing
device. This can be achieved by following these few steps:
●
Turn the temperature knob (“5” from the control panel) up to the
480°C grid.
●
Place the external temperature sensing device’s sensor near the tip
of the hot air gun nozzle.
●
Wait for the Heater LED to start flickering, and the external
temperature sensor to stop rising to provide a stable readout.
●
Slowly turn the CAL or calibration utility (“6” from the control
panel) using a small screw driver until the approximate operating
temperature on both devices are synchronized.
Note
:
Overheat protection is automatically enabled
when the temperature rises to a critical level.
