6
ERASING TEMPORARY DATA
To erase the temporary data (trip, time, avg, max)
twice push the button
M
. rES
will show on the
display. Pick option
M
with buttons
A
and
C
and confirm with button
M
.
PARAMETERS SETTING
To enter the mode of parameter setting press
twice the
M
button. To change a parameter,
use buttons
A
and
C
and for saving the set
parameter press the
M
button.
TURNING ON THE LIGHTING
(IF IT IS INSTALLED)
Turning on the front and rear light is done by
pushing and holding the
A
button for 1 second.
USB PORT
The display is equipped with a micro USB port
for charging of mobile devices (5V/0,5W).
To connect your device with the charging
connector, use any adapter or cable with Micro
USB-B connector.
WALKING ASSISTANT
Walking assistant can be activated by pressing
and holding the
C
button on the control display.
For activation of the assistant assistance mode
must be set to 1-5. This function serves to enable
easier manipulation with e-bike, usually when
walking the bike by your side. The e-bike speed
will be between 4 and 6 km/h. Walking assistant
will be turned off immediately after letting go of
the button.
WARNING: Do not block the e-bike
L
after the activation of the walking
assistant. The motor can get damaged
that
way.
SPEED AND DISTANCE INDICATOR MODE
CHANGE
Change of information displayed on the display
can be done by short press of the button
M
.
Information shows in this order:
rES
– reset of daily kilometres
Un
– unit setting (km / mile)
Ld
– setting of the bike circumference in cm (max. +/- 5 % from the default setting of the circumference)
bL
– display backlight setting in 1-3 range
Ls
– speed limit; value 20 means max. assisted speed of 25 km/h
SPS
– wheel speed sensor signal
Cr
– value of the electric current
TRIP
Lenght of the trip
ODO
Total distance
TIME
Time*
MAX
Maximum speed
AVG
Average speed
ERROR
MESSAGES
Code
Cause of the problem
0X0000
no error
0X0001
controller power tube or over current
0X0002
controller over heat
0X0004
motor phase
0X0008
motor hall
0X0010
motor over heat
0X020
low voltage protection
0X0040
stall protection
0X0080
throttle
0X0100
over-speed beyond control
0X0200
battery communiction
0X0400
pas sensor
0X0800
speed sensor
0X1000
display communication
If the error remains or a different one shows, contact your seller.
