8
NOTE:
!
−
before disconnecting the device from a computer, press the
Disconnect device
button
−
in the event of no response:
−
in the
Software options
, check the number of the COM port
−
make sure that the serial port drivers have been installed correctly (chapter 7)
−
disconnect for a few seconds and then reconnect the recorder to the USB port
−
restart the computer
−
take the battery out of the recorder for a few seconds (as described in chapter 12)
In the event of indications different than the actual value of the input signal, the zero and the sensitivity of a
sensor can be tuned: parameters 11:
calO
(zero) and 12:
calG
(sensitivity).
Table 9. List of configuration parameters
No.
Name
Description of parameter
User settings
0
RTC
(1)
internal real time clock (chapter 9.1)
RECORDING OPTIONS
(chapter 9.2)
1
Start
recording start time
2
Stop
recording end time
3
MPer
data recording interval
4
SDest
selection of memory to save archive files (to record data)
CONFIGURATION OF THE MEASUREMENT INPUT
(chapter 9.3)
5
inp
type of measurement input
6
rrtd
total resistance of leads for 2-wire RTD sensors and 700 Ω
7
cjte
temperature of cold thermocouple tips
8
dot
position of the point/resolution
9
rbot
bottom of the indication range (start of the scale) for 0 mA, 4 mA, 0 V, 0 mV, and
0 Ω
10
rtop
top of the indication range (end of the scale) for 20 mA, 10 V, 60 mV, and 700 Ω
11
calO
calibration of the zero
12
calG
calibration of the inclination
ACCESS OPTIONS
(chapter 9.4)
13
bloc
block of the “
COPY
” button
14
Pass
card authorization password
15
Prot
SD card authorization demand
16
ID
(1)
identification number, ID (recorded in the csv archive file)
DISPLAY OPTIONS
(chapter 9.5)
17
LCDmod
operation mode of the display
18
LCDupd
interval of display update in the continuous mode
19
LCDch
value to be displayed
CONFIGURATION OF ALARMS
(chapter 9.6)
20
AHigh
high alarm for the measured value
21
Alow
low alarm for the measured value
Notes: (1)
– parameter accessible only from the level of ARSOFT-CFG WZ1 (on-line configuration)