The loudspeaker is easy to install, due to its simple mounting system.
(1)
Use the cutout template to mark the mounting hole.
(2)
When making the hole in your mounting panel, double check if there are no cables
or any other obstructions behind the mounting panel. Cutting the mounting panel
without this check might result in damaged infrastructure or power lines. Please make
sure that the mounting structure is capable of safely supporting the loudspeaker’s
weight.
(3)
Remove the speaker grille: turn the mounting clamps (dog-ears) outwards and push
them in the direction of the grille until it pops out. Remove the grille.
(4)
Turn the dog-ears inwards again and tighten the dog-ear screws slightly to make them
stay in the inward position.
(5)
Connect the loudspeaker wires and insert the loudspeaker in the pre-cut loudspeaker
opening.
(6)
Fasten the dog-ear screws carefully until the loudspeaker sits safely in place. Do not
overtighten the dog-ear screws!
(7)
Carefully push the grille back in place.
Mounting the loudspeaker
1
2
3
6
4
7
5
WWW.APART-AUDIO.COM
loudspeaker system
2-way
woofer size
8 inch
woofer cone material
polypropylene
tweeter size
1 inch
100 volt power taps
6 - 3 - 1.5 watts
frequency response
50 - 20 kHz
SPL 1W/1m
88 dB
max SPL 1m
96 dB
dispersion angle 1000 Hz
180°
main construction material
ABS plastic
grille main material
aluminium
IP rating
54
mounting system
3 screws
outside diameter
244 mm
depth
87 mm
cutout diameter
223 mm
min / max ceiling thickness
3 - 27 mm
net weight product
1.24 kg
