www.apcoaviation.com
9 RISERS
The Play42 MKII risers have two brake pulley positions; higher or lower (see
drawing). The factory default is the higher position. For paramotor use or for other
reasons you may alter this brake position. To do so, follow these steps:
1. Mark the brake handle knot position using a pen.
2. Open the brake line knot, remove the handle and brake line from the pulley.
3. Unhook the pulley from the webbing on the riser and hook it in the lower
position.
4. Thread the brake line through the pulley.
5. Re-knot the brake line 15 CM lower from the pen marking you made in step 1.
6. Repeat these steps for the second riser.
Note: always test-inflate you glider after adjusting brake position.
The Play42 is supplied with a split A riser. The first A-riser is attached to the
outermost A line (A5). The second A-riser is attached to the central two A lines (A1 &
A3). This is to facilitate
big ears
or
tip tucks
. At no time should the pilot change the
risers or use risers not intended for this specific glider as this will affect the
performance and safety of the glider.
Page 8 of 24
Summary of Contents for Play 42 MK-II
