A54-3144-XR • Rev B
39
APCON, Inc.
Chapter 5: Configure the chassis
This chapter provides different methods to configure an I
NTELLA
F
LEX
XR chassis.
Default settings
After you have set up the ACI-3144-XR chassis and applied power, change the default
IP address to a number assigned for your network.
By default, the ACI-3144-XR ships with its Active Controller LAN 1 management port set as
follows:
Following are the ways in which you can configure the IP address for the chassis:
• Directly change settings on the LCD touch screen built into the physical unit
• Log into the network, connect the unit to the network, and use the embedded
W
EB
XR software
• Log into the network, connect the unit to the network, and use the embedded
command-line interface (CLI)
Each of these options are explained in the sections that follow.
Chapter 5
Configure the chassis
Chapter 5
Use the front panel interface 40
Use CLI to configure the chassis 64
Identifier
Setting
IP address
192.168.0.1
Subnet mask
255.255.255.0
Gateway
None
NOTE
Unless your network is already set up with
192.168.0.x
as a base address and
uses a subnet of
255.255.255.0
, the default settings for the chassis do not work.
You must change this default IP address to settings appropriate for your network.
