6
How to Replace Stage-2 Carbon Filter (CT-24CAB)
Change every 6-8 months or 600-800 gal pure water used:
The Stage-2 Pre-Carbon filter is on top of Stage-1 Sediment filter (See
Figure E
).
Locate it, and follow these steps:
Step 1.
Step 2.
Disconnect tubing from Point
F
& Point
G
(See
Figure E
). Discard used Filter.
(Follow “Quick-Connection Guide” for connection tips)
Snap on the new filter onto the 2 holding clips. Make sure the
Flow Direction
“
arrow ”
on
the filter is pointing towards the left direction (See
Figure E
). Re-connect tubing to both ends of
the new filter.
D
I
G
F
E
Stage 2
Stage 1
Flow Arrow
The Stage-1 Sediment filter is under the Stage-2 Pre-Carbon filter (see
Figure E
). For ease of access, pull
and lift both the 1st and 2nd stage filters to the top position. Then, do the following:
Step 1.
Step 2.
Remove the tubing lock (red clip) first. Then disconnect the elbow fitting from Point
D
and dis-
connect tubing from Point
E
(see
Figure E
) Discard used filter. (Follow “Quick-Connection
Guide” for connection tips)
Snap on the new filter onto the 2 holding clips. Make sure the
Flow Direction “arrow ”
on the filter is pointing toward the right direction (see
Figure E
). Re-connect elbow fitting and
tubing to both ends of the new filter.
How to Replace Stage-1 Sediment Filter (CT-1SED)
Change every 6-8 months or 600-800 gal pure water used:
Flow Arrow
4. How to Replace Filters:
The new unit will come with 2 plastic ties. Please cut the ties with a pair of
scissors. This will then allow you to remove and replace the filters. Once the filters are replaced the unit
does not have to be tied down, this is only for shipping purposes.
Figure E
