PT1. This button is used to setup time, choose cooking time length, high and low
temperature.
PT2. This knob is for setting operation and the start and end of programmer.
DSP1. This displays the time of programmer executing and clock
DSP2. This displays temperature and types of foods.
DSP3. Functions indication, which displays all the optional functions.
DSP4. Symbol indication, which displays all the optional symbols.
Functions Description
Steam Meat
Fish Vegetable
Roast Pizza
Defrost Disinfecting
Clock Child lock
Cooking duration Delay time
Descaling Water level (not lack of water)
Water level (lack of water) Temperature
7
、
GET TO KNOW STEAM OVEN
7.1 Clock Setting
When the first use, DSP1 shows a flashing“0
:
00”.
Set the time, turn PT1 to the right and left to increase or decrease the hours. After setting
the hour, press it once to set the minutes. Turn it the right and left to increase or
decrease the minutes and press it to set the current time
,
after the setting, press PT1 to
confirm. The symbol “
” displays, and the indication lamp stops flashing.
When you want to set clock again, keep PT1 pressed for 3 seconds,DSP1,Led
display begin flashing, set clock according to Clock Setting procedure(when there is no
any operations in 10 seconds ,it will go to next instruction automatically)
Clock set range: 0:00 - 23:59.
7.2 Water level
Under initial state, you will hear a “beep” after positioning the water tank into position,
and water level indicator “
” will light. If water in tank is not up to standard, lacking
water indicator “
” will light. Please add water to Max position. (Tank could load 1.2ml
water in maximum. A tank full of water generally is able to cook for one time, about 60-70
minutes)
Note: 1
、
Please remove the water tank to add water. Please add water through the
water injection hole. Please wipe clean if water overflowed.
2
、
Add water when the oven is working Open the oven door for a while to cool
down the water tank. Then remove the water tank to add water.