APEN GROUP SPA reserves the right to make changes deemed to be required to its products or documentation
AH-New
condensing air handling unit
22
code HG0310.05GB ed.A-2010
AH
23
code HG0310.05GB ed.A-2010
AH
1 2 3 4
1
2
3
4
5
6
7
8
9
10
M1
M2
4
3
2
1
+VIN
GND
A+
B-
M1
10
9
8
7
6
5
4
3
2
1
ID1
GND
ID2
GND
NTC1 AGND NTC2 AGND
AN3/
NTC3
AGND
M2
10:15
Mon 01 Jan
AN1_Ext
AN2_Ext
AN3_Ext
NTC_On Board
Inputs
OK
T_RIF 20.0
T_RIF 22.3
NONE -10.0
T_RIF -10.0
The inputs that may be displayed inside the menu are:
•
NTC_On Board
•
AN3_Ext
•
AN1_Ext
•
ID1_Ext
•
AN2_Ext
•
ID2_Ext
The menu comprises the following
AN2_Ext
NONE -10.0
Input
Name
Associated
reference
Measured
value
Offset
menu
If the probe is not connected the “NONE” indication is displayed
and next to it the “-10.0” value:
AN2_Ext
NONE -10.0
If there is a probe reading error or incorrect probe connection/
configuration, the following condition is present:
AN3_Ext
T_RIF -10.0
By pressing the
key next to an input, it is possible to
access the offset adjustment menu. This menu allows to correct
the reading value for that specific probe and is represented by
a page as the one below:
0.5
°C
10:15
Mon 01 Jan
Offset
OK
4.3.
Remote On/Off (OPTIONAL)
Any priority ON/OFF contact can be remotely controlled from the
Smart Web remote control, by connecting to terminals 1 (ID1)
and 2 (GND) of the terminal board M2 of the chronothermostat
and removing the existing jumper, as shown in the following
wiring diagram. See HG0060.00 manual, paragraph 9. "Electrical
Connections", supplied with the remote control.
The ON/ OFF contact has priority with respect to the heat
request of time ranges or manual mode, but not with respect to
the snow function heat request, which is independent (optional,
depending on the model).
ELECTRICAL CONNECTION
REMOTE ON/OFF
