- 7 -
3.2.5. — The key for data saving and recalliing
(a) When in measurement mode, short press to save the measurement data; Long press to recall the
saved data.
(b) When in parameter setting mode, press the key to make changes.
3.3
Data Log, Recall and Delete
3.3.1. Save the measurement:
In measurement mode, when the reading is stable and stays on screen, short press
to save
the measurement data.
M+
icon and the data serial number will show up on the upper right corner. The
meter can store up to 400 sets of data.
3.3.2. Recall saved data:
(a) In measurement mode, long press
, the meter will recall the last saved data and the serial
number.
RM
icon will appear in the upper right corner of the screen.
Short press
or again, the meter will recall all the data in turn, hold or
to quickly review the data.
(b) In data recalling mode (
RM
and serial number in the upper right corner), short press
to return
to measurement mode.
3.3.3. Delete data:
In data recalling mode, hold
for 5 seconds,
CLr
will show up for 2 seconds, meaning that all the
saved data have been eliminated. Then the meter will return to measurement mode.
4
What’s in the kit
SX751 pH/ORP/Conductivity/DO
meter *1
201T-S plastic pH/ATC three-in-
one combination electrode *1
301Pt-S plastic ORP
combination electrode *1
2301T-S plastic conductivity
electrode *1
DO500 DO electrode *1
Spare AA batteries *2
1413μS/cm conductivity standard
solution (50mL) *1 bottle
DO503 membrane cap (DO
electrode use) *3
DO502 DO electrode inner
solution (30mL) *1
Cathode polishing paper *2
Screw driver *1
pH standard buffer solution
(pH4.00, pH7.00, pH10.01) *1
50ml bottle/each
Operation manual *1
Carrying case *1
