June 2013
2
80-0180-347 Rev. A
Table of Contents
Table of Contents
Warning .............................................................................................. 3
Definitions ........................................................................................... 3
System Overview ............................................................................... 4
Operational Description ...................................................................... 5
Hub Location ...................................................................................... 6
Hub Wiring .......................................................................................... 7
Trim Installation Tools & Equipment .................................................. 8
Door Preparation ................................................................................ 9
Spindle Preparation .......................................................................... 10
Lock Series Configuration ................................................................ 11
Handing the eForce
®
........................................................................ 13
Mortise Cylinder Installation ............................................................. 14
Rex/DPS Cable Installation .............................................................. 15
Mounting the eForce ........................................................................ 16
Battery Installation ............................................................................ 17
Limited Warranty .............................................................................. 18
Troubleshooting ............................................................................... 19
LED Indications ................................................................................ 20
June 2013
19
80-0180-347 Rev. A
TROUBLESHOOTING
The eForce A100 LED is normally off until a credential is presented
and then LED will momentarily turn green if credentials are valid. A
red LED will show if credentials are not valid.
Place known credential card in front of eForce
®
:
If the eForce
®
emits one short tone, but lock does not activate,
check Wiegand data lines for connectivity and proper connec-
tion.
Green light comes on, but lever will not retract latch or deadbolt:
Check the eForce
®
body connection with lock/latch mechanism.
Check the spindle length (see installation instructions).
Check for proper door preparation (refer to door templates).
No lights come on and Operator stays unlocked (unsecured):
Ensure credential card matches reader type (iCLASS or PROX) if
they do not match, the card will not trigger the eForce reader.
Check the eForce
®
body connection.
Check battery level, replace if necessary.
Check that the Battery cover is installed and secured.
Credentials not activating lock:
Trigger access control system to unlock the device.
If this unlocks the lock:
Ensure that credentials are in system database.
Refer to additional EAC documentation.
