Owner’s Guide
23
8.
Pressing MyZone keeps showing “Please Retry.”
a.
Make sure there are no obstacles between the front-left, center, and front-right
speaker and the MyZone sensor in the remote control.
b.
Make sure the remote is pointed at the center speaker when pressing the MyZone
button, and keep it pointed at the center speaker until the MyZone operation
completes. If there are still issues, replace the batteries in the remote control and
try again.
c.
If your Home Theater One Wireless Transmitter is in the back of the room, for
instance if you are using a projector, you will need a IR repeater to use the MyZone
functionality.
9.
Pressing MyZone keeps showing “Unavailable.”
This happens when the system had a difficult time locating your speakers. To correct,
follow these steps:
1.
Make sure each speaker can physically “see” each other.
2.
Remove the grill from the center speaker.
3.
Run the “Refresh Map” command in the Menu.
When the system successfully locates all of the speakers, MyZone will operate.
10.
Added new speakers to the system, but they are not making any sound.
Make sure the new speakers are powered on, then use the Refresh Map menu item
(see the section “Refresh Map” for more details). This will add new speakers to the
system.
11.
I am playing a DVD or Blu-ray disc that has surround sound, but I am only hearing
audio out the left front and right front speakers.
Make sure your Blu-ray or DVD player is properly setup to send surround
information out of the HDMI or digital ports. For systems using HDMI, the best
performance is "Bitstream" mode. For systems using optical or coax digital, make
sure the system is sending out Dolby Digital or DTS, not "downmix" or "PCM."
Please refer to your player's installation manual for detailed instructions.
Home Theater One Wireless Transmitter
6
5. Wireless Speaker Back Panel
The following shows a typical Aperion Wireless speaker back panel. The
speakers must be plugged-in and powered on for the system to work. When the
Home Theater One Wireless Transmitter is powered off, the speakers go into a
low-power standby state and should remain plugged in at all times. The
speakers will "power up" again when you turn on the Home Theater One
Wireless Transmitter.
Item
Description
1
ASSOCIATE Button (for initial setup only).
2
Service Port - Warning: Do not plug anything into this port. Doing so will cause damage
to the speaker. For factory use only!
3
Status LEDs:
1.
One Blinking Green LED
– Speaker is in low-power mode.
2.
One Fast-Blinking Green LED
– Speaker is in ASSOCIATE mode.
3.
One Blinking Green and One Solid Green
– Speaker is on and communicating with
the Home Theater One Transmitter.
4.
Yellow and/or Red Flashing
– Indicates network issues.
4
AC Power Connection
2
3
4
2
1
W A R N I N G
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
WARNING: Do Not Open! Risk of Electrical Shock. Voltages in this equipment
are hazardous to life. No user-serviceable parts inside. Refer all servicing to
qualified service personnel.
