Extended functions and connections
23
Backjump
(DIP 6)
Important information!
You can set DIP switch 6 to ON for sectional doors or doors
with ceiling guides; this relieves the operator and door
mechanisms. Simpler actuation of the emergency release.
Serves to relieve the door and operator mechanical system. After reaching
the door CLOSE end position, the operator moves in the direction of door
OPEN, relieving the mechanical system.
DIP switch 6
OFF
Disabled
ON
Activated
Connecting photo eye
•
Approved wiring cross-section: max. 0.75 mm².
8 9
10 1
1 12
7
2
1
ON
DIP
3 4
5 6
8
7
Important information!
A second button cannot be connected in parallel.
Terminal 7 + 8
Safety connection, only if DIP switch 2 “OFF”
Terminal 9 + 10 Regulated DC 24 V, max. 0.1 A
Terminal 9:
DC 24 V
Terminal 10:
Earth
Settings: see Obstacle detection (DIP 1, 2 + 3)
Pulse sequence of door movement
(DIP7)
2
1
ON
DIP
3 4
5 6
8
7
1x
1x
1x
1x
STOP
STOP
•
DIP switch 7 OFF, standard setting for all operators: o
pen - stop -
close - stop - open …
•
DIP 7 ON:
Button 1: open - stop - open - stop - …
Button 2: close - stop - close - stop - …
Carriage circuit board
5
2
1
4
6
7
8
3
Terminal
1
Chain current draw
2
Track current draw
3 + 4
Door OPEN limit switch
5
Motor cable
6
Motor cable
7 + 8
Door CLOSE limit switch
Defi ned opening and closing
(DIP 7)
Important information!
With this function, only button 1/radio channel 1 opens
the door and button 2/radio channel 2 closes the door.
Button 1/channel 1 opens and button 2/channel 2 closes the door.
This function can also be used with only 2 buttons or just with handheld
transmitters.
Requirement:
DIP switch 8 OFF, button 2 connected (DIP switch 2 ON) or 2 handheld
transmitter buttons programmed.
